Home » Our Product » Asbestos Jointing Sheets » CJ - 27Oil

CJ - 27Oil

Asbestos Gasket Jointing Sheet Without Wire

Material Composition:
Made from Chrysotite Asbestos Fiber with Synthetic Elastomers and Inorganic fillers.

Applications:
Suitable for use with internal combustion engines, compressors, Refrigerators, chemical plants, etc. This grade also provides effective sealing against hot oils, tar oils and chlorinated & aromatic hydrocarbons under high stress conditions.






Associated Scientific and Engineering Works
THICKNESS : 0.25mm, 0.5mm, 0.8mm, 1mm, 1.5mm, 2mm, 3mm, 4mm, 5mm , 6mm (OTHER THICKNESS ON REQUEST)
SURFACE FINISH : Green/Green ( OTHER COLORS ON REQUEST)
DIMESNSION OF SHEETS : 1500MM X3100MM, 1500MM X1500MM, 1500MM X 1000MM, 1500MM X 2000MM, 1270MM X1270MM,
1270MM X 3810MM, 3000MM X 3000MM
OPERATING CONDITION : Maximum pressure : 150 Bar
Maximum Temperature: 550°C
SPECIFICATION COMPLIANCE : IS: 2712 / 1998 GRADE O / 1, W / 1
Associated Scientific and Engineering Works

   The following Information Applies to material Thickness 1.5mm.

Associated Scientific and Engineering Works
S.NO. Typical Properties Test Method Unit Specified Value
1 DENSITY IS:2712/1998 G/cm3 2.20
2 TENSILE STRENGTH IS:2712/1998 Mpa >24.0
3 COMPRESSIBILITY IS:2712/1998 % 6 -14
4 RECOVERY IS:2712/1998 % >40
5 IGNITION LOSS IS:2712/1998 % <28
6 Stress Resistance IS:6210/1979 Mpa >23
7 FLUID ABSORPTION
(a) Thickness Increase IS:2712/1998 % <25
(b) Mass Increase IS:2712/1998 % <20
IN FUEL B
(a)Thickness Increase IS:2712/1998 % <20
(b) Mass -Increase IS:2712/1998 % <20
IN WATER
(a) Mass - Increase IS:2712/1998 % <10
Associated Scientific and Engineering Works

   NOTE
   All information and recommendations given in this brochure are correct to the best of our knowledge. However, in view of the wide varsity of possible installation and operating conditions one cannot
   draw the final conclusion in all application cases regarding the behaviour in a gasket joint. Therefore, information can only serve as a guideline.