Home » Our Product » Asbestos Jointing Sheets » CJ - 29 Acid Its

CJ - 29 Acid Its

Asbestos Gasket Joitning Sheet Without Wire

Specification Compliance
  Made from Chrysotite Asbestos Fiber with Synthetic Elastomers and Inorganic fillers.

Applications:
  To seal of aggressive organic acids alkalies, alcohals, easters & ketones.






Associated Scientific and Engineering Works
THICKNESS : 0.25mm, 0.5mm, 0.8mm, 1mm, 1.5mm, 2mm, 3mm, 4mm, 5mm , 6mm (OTHER THICKNESS ON REQUEST)
SURFACE FINISH : White
DIMESNSION OF SHEETS : 1500MM X3100MM, 1500MM X1500MM, 1500MM X 1000MM, 1500MM X 2000MM, 1270MM X1270MM,
1270MM X 3810MM, 3000MM X 3000MM
OPERATING CONDITION : Maximum pressure : 150 Bar
Maximum Temperature: 210°C
SPECIFICATION COMPLIANCE : DIN : 3754 IT;S
Associated Scientific and Engineering Works

The following Information Applies to material Thickness 1.5mm.

Associated Scientific and Engineering Works
S.NO. Typical Properties Test Method Unit Specified Value
1 Density DIN 3754 G /cm3 2.20
2 Tensile Strength DIN52910 N/mm2 >6
3 Compressibility IS:2712/1998 % 6 -14
4 Recovery IS:2712/1998 % >40
5 Ignition Loss DIN 52911 % <28
6 ACID ABSORPTION
(A) THICKNESS INCREASE
(a) In nitric acid (40%) SPEC. % 5 -15
(b) In hydrochloric acid (25%) % 5 -10
(c) In phosphoric acid (85%) % 0-5
(d) In sulphuric acid (96%) % 15-40
(e) In sulphuric acid (65%) % 0 -20
(B) WEIGHT INCREASE
(a) In nitric acid (40%) SPEC. % 5 -15
(b) In hydrochloric acid (25%) % 1 -6
(c) In phosphoric acid (85%) % 1-5
(d) In sulphuric acid (96%) % 10-50
Associated Scientific and Engineering Works

   NOTE
   All information and recommendations given in this brochure are correct to the best of our knowledge. However, in view of the wide varsity of possible installation and operating conditions one cannot
   draw the final conclusion in all application cases regarding the behaviour in a gasket joint. Therefore, information can only serve as a guideline.