Home » Our Product » Asbestos Jointing Sheets » CJ - 30 F

CJ - 30 F

Asbestos Gasket Jointing Sheet Without Wire

Material Composition:
Made from Chrysotite Asbestos Fiber ,Nitrile Butadine Rubber

Applications:
Suitable to seal off Motor oil, Carburetor mixture, most transmission and hydraulic fluids refrigerating oils, fuels, steam, alkalies, water/antifreeze and water/anti-corrosion mixtures. this grade offers high oil and fuel resistance.






Associated Scientific and Engineering Works
THICKNESS : 0.25mm, 0.5mm, 0.8mm, 1mm, 1.5mm, 2mm, 3mm, 4mm, 5mm , 6mm (OTHER THICKNESS ON REQUEST)
SURFACE FINISH : Green, Graphited (OTHER COLORS ON REQUEST)
DIMESNSION OF SHEETS : 1500MM X3100MM, 1500MM X1500MM, 1500MM X 1000MM, 1500MM X 2000MM, 1270MM X1270MM,
1270MM X 3810MM, 3000MM X 3000MM
OPERATING CONDITION : Maximum pressure : 50 Bar
Maximum Temperature: 450°C
SPECIFICATION COMPLIANCE : IS: 2712 / 1998 GRADE W / 1
Associated Scientific and Engineering Works

   The following Information Applies to material Thickness 1.5mm.

Associated Scientific and Engineering Works
S.NO. Typical Properties Test Method Unit Specified Value
1 DENSITY ASTM F104 G/cm3 2.20
2 TENSILE STRENGTH ASTM F104 Mpa >24.0
3 COMPRESSIBILITY ASTM F104 % 7 -12
4 RECOVERY ASTM F104 % >50
5 IGNITION LOSS ASTM F104 % <28
6 FLUID ABSORPTION
Water Absorption
(a) Mass Increase ASTM F104 % <10
7 IN ASTM OIL NO 3
(a) Thickness Increase ASTM F104 % 10
(b) Mass Increase ASTM F104 % 15
8 FUEL B
(a) Thickness Increase ASTM F104 % 10
(b) Mass Increase ASTM F104 % 10
Associated Scientific and Engineering Works

   NOTE
   All information and recommendations given in this brochure are correct to the best of our knowledge. However, in view of the wide varsity of possible installation and operating conditions one cannot
   draw the final conclusion in all application cases regarding the behaviour in a gasket joint. Therefore, information can only serve as a guideline.