Home » Our Product » Asbestos Jointing Sheets » CJ - 33 CS

CJ - 33 CS

Asbestos Gasket Jointing Sheet Without Wire

Specification Compliance
  Made from Chrysotite Asbestos Fiber with Synthetic Elastomers and Inorganic fillers.

Applications:
  Suitable for controlled swelling in oil medium stress conditions & is suitable for internal combustion engine as well as in compressors pipe system.






Associated Scientific and Engineering Works
THICKNESS : 0.25mm, 0.5mm, 0.8mm, 1mm, 1.5mm, 2mm, 3mm, 4mm, 5mm , 6mm (OTHER THICKNESS ON REQUEST)
SURFACE FINISH : Yellow
DIMESNSION OF SHEETS : 1500MM X3100MM, 1500MM X1500MM, 1500MM X 1000MM, 1500MM X 2000MM, 1270MM X1270MM,
1270MM X 3810MM, 3000MM X 3000MM
OPERATING CONDITION : Maximum pressure : 100 Bar
Maximum Temperature: 500°C
SPECIFICATION COMPLIANCE : ASTM:F104 F112950 M 7
Associated Scientific and Engineering Works

The following Information Applies to material Thickness 1.5mm.

Associated Scientific and Engineering Works
S.NO. Typical Properties Test Method Unit Specified Value
1 Density ASTM F104 g /cm3 2.20
2 Tensile Strength ASTM F104 Mpa >26.0
3 Compressibility ASTM F104 % 6 -14
4 Recovery ASTM F104 % >40
5 Ignition Loss ASTM F104 % <28
6 Stress Resistance ASTM F104 Mpa >23
7 FLUID ABSORPTION
IN ASTM OIL NO.3
(a) Thickness Increase ASTM F104 % 20 - 40
(b) Mass Increase ASTM F104 % 15 - 30
IN FUEL B
(a)Thickness Increase ASTM F104 % 20 - 40
(b) Mass -Increase ASTM F104 % 10 - 20
IN WATER ASTM F104 %
(a) Mass - Increase ASTM F104 % <10
Associated Scientific and Engineering Works

   NOTE
   All information and recommendations given in this brochure are correct to the best of our knowledge. However, in view of the wide varsity of possible installation and operating conditions one cannot
   draw the final conclusion in all application cases regarding the behaviour in a gasket joint. Therefore, information can only serve as a guideline.