Home » Our Product » Asbestos Jointing Sheets » CJ - 43

CJ - 43

Asbestos Gasket Jointing Sheet Without Wire

Specification Compliance
  Made from Chrysotite Asbestos Fiber with Synthetic Elastomers and Inorganic fillers.

Applications:
  To seal of aggressive organic acids alkalies, alcohals, easters , ketones ,diluted acids, solvents, mineral oils and thermal oils under high stress
  conditions.






Associated Scientific and Engineering Works
THICKNESS : 0.25mm, 0.5mm, 0.8mm, 1mm, 1.5mm, 2mm, 3mm, 4mm, 5mm , 6mm (OTHER THICKNESS ON REQUEST)
SURFACE FINISH : Grey , Graphited (OTHER COLORS ON REQUEST)
DIMESNSION OF SHEETS : 1500MM X3100MM, 1500MM X1500MM, 1500MM X 1000MM, 1500MM X 2000MM, 1270MM X1270MM,
1270MM X 3810MM, 3000MM X 3000MM
OPERATING CONDITION : Maximum pressure : 200 Bar
Maximum Temperature: 550°C
SPECIFICATION COMPLIANCE : ISI : DIN : 3754 IT ; O ;
3754 IT ; S
3754 IT ; 400
Associated Scientific and Engineering Works

The following Information Applies to material Thickness 1.5mm.

Associated Scientific and Engineering Works
S.NO. Typical Properties Test Method Unit Specified Value
1 Density IS:2712/1998 g /cm3 2.20
2 Tensile Strength IS:2712/1998 Mpa >26.0
3 Compressibility IS:2712/1998 % 6 -14
4 Recovery IS:2712/1998 % >40
5 Ignition Loss IS:2712/1998 % <28
6 Stress Resistance IS:6210/1979 Mpa >23
7 FLUID ABSORPTION
IN ASTM OIL NO.3
(a) Thickness Increase IS:2712/1998 % <20
(b) Mass Increase IS:2712/1998 % <15
IN FUEL B
(a)Thickness Increase IS:2712/1998 % <15
(b)Mass - Increase IS:2712/1998 % <15
Associated Scientific and Engineering Works

   NOTE
   All information and recommendations given in this brochure are correct to the best of our knowledge. However, in view of the wide varsity of possible installation and operating conditions one cannot
   draw the final conclusion in all application cases regarding the behaviour in a gasket joint. Therefore, information can only serve as a guideline.